Nearly all of the time, businesses would spend lots of money to buy their lift trucks. It is important, therefore to take good care of your machine to protect your investment into the long run. It is really a good idea to know the procedures that are carried out in the care and maintenance of this piece of equipment.
By starting up the forklift and listening carefully how it runs is among the best ways to tell how good the engine is performing. For example, if there are any knocks or misses, the machinery is defective and this must raise some concerns. Additionally listen carefully for any squealing sounds which come from the belts because these sounds will provide you with a lot of information.
When performing maintenance, some of the main components you will have to pay attention to comprise the safety warning devices, horn, the lights, the gauges and the overhead guard. Any faulty parts or burnt out light bulbs have to be replaced as soon as they are noticed. It is also essential to inspect the wiring.
The battery compartment terminals should be cleaned after the above components have been inspected thoroughly. If the terminals are not clean, be sure to clean them well. Each cell of the battery must be checked so as to make sure that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machinery and after that change the filters. The transmission filter, fuel filters and the hydraulic filter must be regularly replaced. Prior to fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
When the oil change is done and the filters have been replaced, a visual inspection of the drive axle has to be carried out. If there is a grease fitting on the axle make sure to apply some grease. Check the belts on the engine for any cracks or frays. If you find any, fix the issue accordingly. Afterwards, inspect every other component of the equipment like the wheels. If any type of fault or problem is detected, be certain to deal with it immediately in order to make sure the machine is running at its safest and optimum levels.